I think now the heat for Mem is not a problem any moresince I add a home-made memory cooling system for this guy. i find the abit k8vpro 2 mem slots are so close to each other. the inside heat is hard to be blowed off. I use an old coolermaster cpu fan to attach on the memory, and a small cable to fasten it. now even @275Mhz full load for memory, i can not feel it warm when i use hand to tough it( of course, i need to clear the static first by touching the casing :-).) if you are insterested my work, i can take a photo of it, after i finish that i feel the cpu temp is also affected--cooled down by around 8-10 degree. now for the system since i will not oc the cpu further and the heat is not a problem for memory, i believe any instability is caused the hardware physical quality and bios settings (also maybe the microsoft OS disability but yet i have not tested the pc under linux or solaris). now the pc sometimes hangs when playing games @275*9 v cpu@1.55 mem@2.80. I think maybe it is caused by the nvidia drive (more...)
very good work :), I'm trying to cool the mem
but i cannot find a suitable "active" cooler for mem, :(
I really want to have a look how you make it.
last night i tried 270*9, 1:1, 3600MB/s, and it hangs my system when I play chancast, an emulator for DC, It only hangs on a specific background, which requires full load of CPU floating point arithmetic, after entering that sence, it hangs after around 10s. when i switch back to 250*10, it works fine.
I disabled pagefile on win xp, sp2. Tonite i will enable it and test again.
but i think maybe we can try to use higher voltage on CPU and HyperTransport and northBridge, I checked a lot forums and find someone do some hard mod on MB to get 3.1V for mem.
There are many settings one can tweak from hardware to software, we need to try them out:)
following link shows a vtt mod for kv8pro
http://www.xtremesystems.org/forums/showthread.php?s=&threadid=38946
I really want to have a look how you make it.
last night i tried 270*9, 1:1, 3600MB/s, and it hangs my system when I play chancast, an emulator for DC, It only hangs on a specific background, which requires full load of CPU floating point arithmetic, after entering that sence, it hangs after around 10s. when i switch back to 250*10, it works fine.
I disabled pagefile on win xp, sp2. Tonite i will enable it and test again.
but i think maybe we can try to use higher voltage on CPU and HyperTransport and northBridge, I checked a lot forums and find someone do some hard mod on MB to get 3.1V for mem.
There are many settings one can tweak from hardware to software, we need to try them out:)
following link shows a vtt mod for kv8pro
http://www.xtremesystems.org/forums/showthread.php?s=&threadid=38946
Ping Money: Destination Unreachable
Ping Life: Unkown Host
Ping Future: Reply From Hell: 0bytes time=0ms TTL=1
Huasing Association 1999 - 2013